Knowledge Center
Practical machining knowledge: tool selection guides, cutting parameters, tool materials and coatings, application cases and FAQs.
7 article(s)
Case Study: Roughing and Finishing Ti-6Al-4V Aerospace Brackets
How a machining workshop cut cycle time 38 percent on Ti-6Al-4V brackets using dynamic roughing plus high-helix finishing, with fu...
PCD vs CVD Diamond Coating vs Solid Carbide: Choosing the Right Tool Material
A comparison of polycrystalline diamond, CVD diamond coating and coated carbide: hardness, edge quality, cost per part and best ap...
涂层技术趋势：从 TiAlN 到金刚石涂层，涂层决定刀具寿命上限
涂层是现代刀具的核心技术环节——基体决定韧性，涂层决定耐磨。了解主流涂层的特性差异，是选好刀、用好刀的基础。
PCD End Mill Cutting Parameters for Graphite and CFRP Machining
Recommended speeds, feeds and strategies for polycrystalline diamond end mills in graphite electrodes and carbon fiber composites,...
How to Select the Right End Mill for Aluminum Alloy Machining
A practical guide to flute count, helix angle, coating and geometry choices for machining 6061, 7075 and cast aluminum alloys with...
微径铣刀与微小切削加工：小刀具里的大工艺
随着 3C 电子、医疗器械与模具微细结构加工需求的爆发，微径刀具（直径 1mm 以下）的工艺要点成为精密加工企业的必修课。
硬质合金立铣刀选用要点：螺旋角、刃数与涂层如何取舍
同一支铣刀不可能适合所有工况。从材料硬度、加工工序到机床刚性，立铣刀选型需综合考量螺旋角、刃数、涂层与刃长的匹配关系。
Contact Info
- Address: China
- Email: service@exactalloy.com
